You Will Meet You The Steve Jobs Of The Peugeot 308 Key Fob Industry

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a little old but it's still appealing. It might not be the plushest car in its class and a Ford Focus or Volkswagen Golf will protect you from sloping surfaces - but it's a relaxed and comfortable driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is constant or intermittent.

Water Damage

If you happen to leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's most likely to suffer water damage. Keep your key fob in a dry container whenever you are outside or perform things that expose it to excessive water.

You'll also need to ensure that the fob is dry prior to opening it and using it again. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indicator that it is submerged.

A wet circuit board can cause the battery's charge to drop its energy or even explode. If you can get your keyfob 308 out of the water, turn the button side up and shake as much water out as you can prior to opening the casing. Once you have opened it, take off the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not function include a dead coin-cell battery or receiver module issue, signal interference or a faulty chip. If none of these causes the reason, you may try resetting your system by disconnecting the 12 volt battery for approximately 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start technology that allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the car before they get in. This feature is extremely beneficial particularly during the cold winter months. The remote start system can cease to function for a variety reasons, such as the dead battery in the coin-battery.

A coin-shaped battery in the key fob has a lifespan of two to four years, depending on how often it is used and where it's purchased. The use-by date will be printed on the package or marked in the user's manual.

If the key fob stops functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob has been exposed to soapy or salty water, it could have caused the chip to become damaged. It is recommended to replace it.

If you're not certain that the battery is not working properly You can test the voltage with a multimeter that is set to the car's voltage range and connected to the plus and minus terminals. If the voltage is less than 12-13 volts you need to replace the battery. If you want to, you can try to reset the onboard computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the part that transmits an alarm to the car when the key fob is activated, it also acts as an immobiliser, and stops it from starting until the key that you want to use is present.

This could result from a variety of factors including water damage or simply aging. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be due to the fact that the keyfob was exposed it. In this scenario, you'll need to remove it and thoroughly clean it with isopropyl or an electronic cleaner. When the battery is dry, you can try again.

If the issue is not resolved, it is a good idea that you visit a local Peugeot expert or locksmith. They'll utilize a diagnostic tool to help pinpoint the issue and fix it.

Losing your Peugeot keys to your car can be an incredibly stressful experience. However, a qualified auto locksmith can address the issue in only a few minutes. They can program your vehicle and cut a new, functioning key for you. Find a locksmith in your area.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob is an important part of the remote control system. If it becomes damaged, your car may not start or you may receive a message that reads "anti-theft active". If this occurs, the only way to fix the issue is to get a new key. Auto locksmiths with experience are able to offer the fastest possible time.

The chip inside your Peugeot 308's key fob may fail due to many reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, take it to the cleaners immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. Then, you need to allow the battery to completely dry.

Radio interference can cause the key fob's functionality to cease. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this issue, it is best to visit the Peugeot dealership.

The Peugeot 207/308 Key Fob is delicate and needs special care. It should not be dropped or throw it around. If you lose something, try to find it as soon as you can. replacement key for peugeot partner van can reset your on-board computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.

Edit

Pub: 30 Jun 2024 02:03 UTC

Views: 10