Some Of The Most Ingenious Things Happening With Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be a little old however it's still eye-catching. It might not be the plushest car in its class and an Ford Focus or Volkswagen Golf will shield you from imperfections on the road - but it's a relaxed and civilised drive.

We often receive requests from Coded Car Keys to replace peugeot key fobs. Whether the problem is persistent or intermittent the following suggestions should help.


Water Damage

If you accidentally drop your fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it's likely to sustain water damage. The best way to prevent this from happening is to always keep it in a dry, dry bag when you're going outdoors or doing things where the fob might be exposed to large amounts of water.

It's also crucial to make sure the fob has completely dried before you open it to use it again. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's been submerged.

A wet circuit can cause the battery's power to be depleted or even explode. If you can pull your 308 keyfob out of the water it is best to turn the button side up and shake as much water out as you can before opening the casing. After opening it, remove the battery and clean the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery, receiver module problems, signal interference or a damaged chip. If none of these are the reason you can restart the system by disconnecting the 12 voltage battery from the car for 15 mins.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the car prior to entering. This feature is very beneficial especially during the cold winter months. However, there are times when the remote start system stops operating due to a range of reasons, including the battery of a coin that is dead.

The coin-shaped battery that is within the key fob may last between two and four years depending on how frequently it is used, the location it was purchased and how it is utilized. Its use-by date is typically printed on the package or listed in the instruction manual.

If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, then clean the chip with a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have fried the chip. It is recommended to replace it.

If you're unsure whether the battery is in good condition it is possible to check the voltage using a multimeter connected to both the plus and minus terminals. The voltage should be around 12 to 13 volts, however, if it reads lower, the battery needs to be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start.

Faulty Receiver Module

If you don't get the "Key Detected" you might find the receiver module malfunctioning. It's the component that sends an alarm to the car when the key fob is activated which acts as an immobiliser. It also stops it from starting unless the correct key is present.

This could be due to a range of reasons, including water damage or simply aging. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was contaminated with it. In this scenario you'll have to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue continues to persist, it is recommended to consult the local Peugeot expert or locksmith. They'll employ a diagnostic tool identify the problem and fix it.

It can be a stressful experience to lose your Peugeot car key. A reputable auto locksmith can solve the problem within minutes. They can program your vehicle and cut a new, functioning key for you. Click here to find the nearest locksmith.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob plays an essential role in the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message that says "anti-theft". If this happens, the only way to fix the problem is to obtain a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest amount of time.

The chip in the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage, dirt or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, you must take it to the cleaners immediately. peugeot remote key replacement can wipe the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, you should allow the battery to dry completely.

Sometimes keys may stop working because of radio interference. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you experience this issue you should visit the Peugeot dealership.

The Peugeot key fob 207/308 is very delicate and requires special attention. You shouldn't drop it or throw it around. If you lose it, try to find it as quickly as possible. You can reset the on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.

Edit Report
Pub: 24 Apr 2024 07:54 UTC
Views: 45