15 Of The Top Peugeot 308 Key Fob Bloggers You Need To Follow

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit however it's still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing drive.

We often receive requests from Coded Car Keys to replace peugeot key fobs. These tips can assist whether the issue is ongoing or intermittent.

Water Damage

If you happen to leave your key fob in a pool or get it wet while kayaking, swimming canoeing, rafting, or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to large amounts of water.

It is also important to ensure that the fob is completely dry before opening it up and re-using it. If you detect any smells emanating from the fob like an industrial-like smell or a sour taste like windshield washer fluid, this is another sign that it's been submerged in water.

A circuit that is wet can cause the battery's power to be depleted or even explode. If you can pull your 308 keyfob out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. Remove the battery, then clean the circuit board with a cotton swab that has been dipped into 90-percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system could fail to function include the battery of your coin is dead problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of these is the issue, try resetting the system by disconnection of the battery with 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start system which allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to entering. This feature is extremely beneficial particularly during the winter's cold and chilly months. However, sometimes peugeot 207 new key operating due to a range of reasons, like the battery in the coin is dead.

The coin-shaped battery inside the key fob could last between two and four years, based on how frequently it is used, where it was purchased and how it is utilized. The date of use is displayed on the packaging or mentioned in the user's manual.

If the key fob has stopped working after exposure to clean tap water it is recommended to take the battery off, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to be damaged. It is necessary to replace it.

If you are not sure that the battery is not working properly, you can test its voltage using a multimeter set to the car's voltage range. Connect it to the minus and plus terminals. If the voltage is less than 12-13 volts, it is time to replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has developed a fault. It is the part that sends out the signal when your key fob turns on. It also acts as an alarm, and stops the car from starting without the correct key.

This could be due to a number of causes, such as water damage or simply getting old. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was exposed it. In this instance, you'll need to remove it and clean it thoroughly using isopropyl or electronic cleaner. When the battery is dry then you can try again.

If the issue persists, it is a good idea to consult a local Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the problem and fix it.

The loss of your Peugeot keys to your car can be a stressful experience. A certified auto locksmith can solve the problem within minutes. They can program your car and cut a fresh, functioning key for you. Find a locksmith in your area.

Faulty Electronic Chip

The electronic chip in your Peugeot 308 key fob is a very important component of the remote control system. If it becomes damaged, your car may not start or receive a message stating "anti-theft active". In this situation, the only solution is to replace the key. Professional auto locksmiths are able to offer the service in the shortest time.

The chip inside your Peugeot 308 key fob can fail due to sweat, water damage, dirt or other reasons. If your Peugeot key fob was exposed to dirty or soapy water, it needs to be cleaned promptly. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. After that, you should let the battery dry completely.

Sometimes keys may stop working because of radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects around the vehicle. If you have this issue it is recommended to visit the Peugeot dealership.

The Peugeot 207/308 key fob is extremely delicate and requires special attention. You should not drop it or throw it around. If you lose it, try to locate it as quickly as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Remove the negative cable before the positive.

Edit Report
Pub: 25 Apr 2024 08:49 UTC
Views: 38