5 Laws Anybody Working In Peugeot 308 Key Fob Should Be Aware Of
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be a bit old but it's still attractive. It's not the most luxurious vehicle in its class, but it's an enjoyable and comfortable drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. These tips can assist whether the issue is intermittent, or constant.
Water Damage
If you accidentally drop your key fob in a puddle or it gets wet while kayaking canoeing, rafting or canyoning it is likely to be damaged by water. Keep your key fob in a dry bag whenever you go outdoors or do things that expose it to excessive water.
You'll also want to make sure that the fob is dry prior to opening it and using it again. If you notice any odors coming from the fob, such as an industrial-type liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.
A wet circuit board can cause the battery to discharge its charge or even explode. If you're able to pull the 308 key fob of the water body it got stuck in, flip the button side down and shake it out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board down using a cotton swab which has been dipped in 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module malfunction signal interference or a faulty chip. If none of these are the reason, you may try resetting the system by disconnection of the battery with 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to entering. This feature is extremely useful particularly during the winter's cold and chilly months. However, it is possible that the remote stop system stops functioning due to a variety of causes, such as an unresponsive coin battery.
A coin-shaped battery that is found inside the key fob can last for a period of two to four years, depending on how often it's used and where it is purchased. The date of use is usually printed on the packaging or listed in the instruction manual.
If the key fob is not functioning after exposure to clean tap water and you want to remove the battery, then clean the chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. It is recommended to replace it.
If you're not sure whether the battery is in good condition You can test its voltage using a multimeter connected to both the terminals for plus and minus. The voltage should be between 12 to 13 volts, but if it is lower, then the battery needs to be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. peugeot 2008 key www.g28carkeys.co.uk 's the part that sends out an alert when the key fob goes off. It also functions as an alarm and prevents the car from starting if it doesn't have the correct key.
The cause could be many factors, including water damage or simply the aging process. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was exposed it. In this instance, you'll have to take it off and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery has dried you can attempt to test it again.
If the problem persists it is a good idea to see the local Peugeot expert or locksmith. They can use the diagnostic tool to identify the issue and repair it.
It can be a stressful experience to lose your Peugeot car key. A qualified auto locksmith will be able to solve the problem within minutes. They can program your car and cut a new, working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may encounter issues starting your car or receive a message stating "anti-theft". If this occurs, the only way to fix the problem is to replace the key. Auto locksmiths with experience are able to provide the service within the shortest possible time.
The chip in the key fob of your Peugeot 308 may become faulty for various reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned right away. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery should then be allowed to fully dry.
Radio interference can cause a key fob to stop functioning. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It could be caused by unsafe conditions or objects that are within the vicinity of the vehicle. If you encounter this issue you should visit the Peugeot dealership.
The Peugeot Key Fob 207/308 is fragile and requires particular care. You should not drop it or throw it around. If you lose it, try to find it as quickly as is possible. You can reset the on-board computer by disconnection of the battery for a few minutes. Unplug the negative cable prior to the positive.