What Peugeot Keys Will Be Your Next Big Obsession

Peugeot 208 Key Replacement

Peugeot 208 key replacement is best left to auto locksmiths with experience who have the appropriate equipment and know-how. They can design and program keys faster and cheaper than dealers.

A dead coin battery is most likely to blame the reason why your key fob isn't locking or unlocking the doors. There are also other reasons for the key to be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking and unlocking, as well as hindering it from starting the engine. In this case you'll need use the alternative starting method as described in your vehicle's owner's manual.

The spark plugs could also be worn out. The spark plugs are responsible for igniting the fuel which starts the engine. They are only able to last for a short time. If they are not used enough, they will eventually fail.

There is a simple solution to this issue. The best way to solve this issue is to test the voltage of your car battery using a multimeter. If it is below 11.5 volts, then you need to replace it. If the battery is corroded it is necessary to clean its contacts. This can be done by lifting the rubber covers covering the two battery terminals and using a wire brush to remove any corroded areas of the battery. Then, reconnect the positive and negative pole cables.

Water Damage


If your 208 doesn't start and the battery isn't flat then you should check that the spark plugs are in good working order. It could be that they're dirty and don't spark. The spark plugs can be cleaned in the workshop.

Peugeot automobiles are equipped with a transponder that is compatible with the immobiliser. This ensures only the correct key can turn the engine. If the chip inside the Peugeot key is damaged, then it will not transmit the proper signal to the vehicle.

Water damage is a common cause of this issue. This is particularly prevalent in colder climates. the vehicle might have been exposed to snow or rain. If this is the case, contact a reputable auto locksmith who will have all of the tools and equipment needed to modify the new key. They will also have all the latest technology and equipment required to create the Peugeot smart key. The process should take no more than 15 minutes.

Contacts of the battery may be damaged.

Peugeot replaced the old transponder chips with a new model that is based on electronic components that are mounted on a circuit board. This new technology works great when it's fresh, but over time the circuit boards start to wear out and stop functioning properly.

This can prevent the immobiliser's function from being activated, meaning your vehicle won't be able to start. If this happens, it's a good idea to get in touch with a Peugeot specialist or locksmith.

A common issue occurs when the battery inside the key fob starts to die. This causes the blade of the key to stop feeding into the lock. A locksmith from your vehicle can replace the battery and cut a fresh blade for you, it's normally a quick fix.

Faulty Receiver Module

It could be that the receiver module is malfunctioning if your Peugeot key fob stops working after being dropped on the floor, or exposed to a stormy rainstorm, or accidentally washed. The receiver is responsible for transmitting radio frequency signals to the onboard computer, which is responsible for controlling the centralized locking system of your Peugeot vehicle.

The key fob itself has rubber seals to prevent water from reaching the chip inside. The chip can be damaged by water in the event that it is exposed the water for an extended period of time. Submerging the key fob in ocean water at the beach or throwing it into the pool could be particularly damaging due to the high salt content.

If your Peugeot spare key fob isn't working You'll need the module replaced. peugeot key replacement near me is only completed by an experienced auto locksmith or Peugeot specialist. Peugeot keys unlike other automobiles, are secured by an immobilizer system. This requires the proper coding to start the car. This is the reason that you should only trust a Peugeot locksmith to create and program an alternative.

Computer with a problem on board

The on-board computer inside your Peugeot is responsible for many of the systems in your car, from power windows to the airbags. The on-board computer will display a code if something goes wrong. This code will be saved in the system until the issue is resolved. This will often require the on-board computers to be replaced.

One of the most frequent reasons for the airbag light coming on is loose or corroded connectors in the airbag sensor. This could be due to wear and tear, aging, or exposure to salt and moisture. It is essential to have this issue resolved as soon as you can, as an airbag that is malfunctioning can be risky in the event of an accident.

If your Peugeot is showing a card that is not being detected error, the battery in the key fob may be weak or dead. This will stop the key fob sending a signal to deactivate the immobilizer on your vehicle. Try this by pressing the unlock button on the key fob, and then trying to start your vehicle. If it doesn't work, the key battery needs to be replaced.

Edit Report
Pub: 29 Jun 2024 08:56 UTC
Views: 5