25 Surprising Facts About Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit, but it still feels attractive. It might not be the most luxurious car in its class - an Ford Focus or Volkswagen Golf will help you stay away from surface imperfections - but it's a relaxed and a civilized driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will assist whether the issue is intermittent, or constant.
Water Damage
If you accidentally drop your key fob into an eddy, or it gets wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry bag whenever you're out in the open or engaging in activities where the fob could be exposed to excessive amounts of water.
It's also important to make sure that the fob is completely dried out prior to opening it up and then use it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it's been submerged.
A circuit board that is wet could cause the battery to dump its energy or even explode. If you can pull your 308 keyfob out of the water, turn the button side up and shake as much water as you can prior to opening the casing. When you've opened it, remove the battery, and then clean the circuit board with the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module issue signal interference, or a faulty chip. If none of the above are the problem you can reset the system by disconnecting the 12 volt battery from your car for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to entering. This feature is very beneficial particularly in cold winter months. However, there are times when the remote stop system stops working due to a variety of reasons, such as the battery in the coin is dead.
The coin-shaped battery located inside the key fob could last between two and four years based on how frequently it is utilized, the place it was purchased, and how it is used. The date of use is usually printed on the package or listed in the instruction manual.
If the key fob is no longer functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing it. In case of exposure to salty or soapy water, the chip could be fried and you will need to replace the key fob altogether.
If you're not sure if the battery is defective, you can check its voltage with a multimeter attached to both the plus and minus terminals. If the voltage is less than 12-13 volts, you must replace the battery. You can also try to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should now begin.
Faulty Receiver Module
If you aren't seeing the "Key Detected" you might find the receiver module faulty. It's the part that sends a signal to the car when your key fob is activated, which acts as an immobiliser and prevents it from starting until the correct key is present.
This could be due to a variety of causes including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, like, the electronic chip inside may be damaged. In this scenario it is necessary to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. When the battery is clean you can attempt to test it again.
If the problem persists it is recommended to consult a local Peugeot expert or locksmith. They'll make use of a diagnostic device to identify the problem and fix it.
It is stressful to lose your Peugeot car key. A reputable auto locksmith will be able to resolve the issue within minutes. They can cut a brand new key and then program it into your vehicle, making sure you're ready to get out on the road in the shortest amount of time. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message that says "anti-theft". In this scenario, the only solution is to replace the key. Luckily, auto locksmiths who are professionals can provide the service within the shortest period of time.
The chip inside the key fob of your Peugeot 308 may fail due to a variety of reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it should be cleaned right away. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. Then, you need to allow the battery to dry completely.
Sometimes keys can cease to function due to radio interference. This is usually caused by other devices use the same frequency as your Peugeot keyfob. G28 could also be caused by bad weather or objects in the vicinity. It is recommended to see a Peugeot dealer if you experience this issue.
The Peugeot key fob 207/308 is very delicate and requires special care. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first, and then the positive.