20 Myths About Peugeot 308 Key Fob: Dispelled
Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a bit old however it's still appealing. It's not the most luxurious car in its class, but it's an enjoyable and comfortable driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. If the issue is ongoing or continuous, the following tips should help.
Water Damage
If you accidentally drop your key fob in a puddle or it gets wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. Keep your key fob in a dry bag whenever you go outdoors or do activities that could expose it to excessive water.
It's also essential to make sure the fob has completely dried out before you open it up and then use it again. If you notice any odors emanating from the fob such as an industrial-type liquid smell or the scent of windshield washer fluid, it's another sign that it's been submerged in water.
A circuit that is wet can cause the battery's charge to be drained or even explode. If you're able to fish your 308 key fob out of the water in which it got stuck in turn the button upside down and shake it out as much water as possible before opening the case. Once you have opened it, take out the battery, and then clean the circuit board using the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system may not function include the battery of your coin is dead or receiver module issues, signal interference, or a faulty electronic chip. If none of the above is the issue, you can reset the system by disconnecting 12 Volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start that lets drivers start their car from a distance, allowing them to warm up or cool down the vehicle prior to entering. This feature is very beneficial, especially in the cold winter months. Remote start systems may cease to function for a variety reasons, including the battery being dead.
The coin-shaped battery located inside the key fob could last between two and four years, based on the frequency with which it is used, the location it was purchased, and how it is used. The date for use-by is typically printed on the package or in the manual.
If the key fob has stopped working after exposure to clean tapwater, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If exposed to soapy or salty water, the chip might be fried and you will have to replace the key fob in total.
If you're unsure if the battery is defective it is possible to check its voltage using a multimeter attached to both the terminals plus and minus. If the voltage is lower than 12-13 volts you need to replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.
Faulty Receiver Module
If you don't see "Key Detected" message, it could mean that your receiver module is malfunctioning. It is the part that transmits an alert when the key fob activates. It also functions as an alarm that stops the car from starting if it doesn't have the correct key.
This could result from a variety of factors including water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, for example the chip that is located inside may be damaged. In this situation, you'll have to take it off and thoroughly clean it using isopropyl or an electronic cleaner. When the battery is dry you can attempt to test it again.
If the issue continues to persist the issue persists, it's a good option to consult a local Peugeot specialist or locksmith. They can use the diagnostic tool to pinpoint the problem and repair it.
Losing your Peugeot car keys can be a stressful experience. A reputable auto locksmith can solve the problem within minutes. They can program your vehicle and cut a new working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a vital role in the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying "anti-theft". In this scenario the only option is to replace the key. Professional auto locksmiths are able to provide the fastest possible time.
The chip in the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you must cleanse it immediately. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. The battery must then be allowed to completely dry.
Sometimes keys may be inoperable due to radio interference. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects in the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you have this problem.
The Peugeot 207/308 Key Fob is fragile and requires special care. It is crucial not to throw or drop the key fob. If you lose something, try to locate it as soon as you can. You can reset the on-board computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.