5 Laws Anyone Working In Peugeot 308 Key Fob Should Know

Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit however it's still attractive. It's not the plushest car in its class It's a Ford Focus or Volkswagen Golf will shield you from imperfections on the road - but it's a relaxing and comfortable driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If The KeyLab is ongoing or continuous, the following tips should assist.


Water Damage

If you accidentally drop your key fob in an eddy, or it is soaked while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry container when you're out in the open or engaging in activities where the fob could be exposed to a lot of water.

You'll also need to make sure that the fob is completely dry before opening it up and using it again. If you notice any odors emanating from the fob such as an industrial-type liquid smell or that of windshield washer fluid, it's another sign that it's been submerged in water.

A circuit board that is wet could cause the battery to lose its charge or even explode. If you can remove your 308 keyfob out of the water you need to turn the button side up and shake as much water out as you can before opening the casing. After opening it, take out the battery, and then clean the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system might not function include a dead coin-cell battery or receiver module issue signal interference, or a damaged chip. If none of these are the problem you can reset the system by disconnecting 12 Volt battery from the vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start systems that allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is very useful, especially in the cold winter months. However, there are times when the remote start system stops working due to a variety of reasons, such as the battery in the coin is dead.

A coin-shaped battery that is in the key fob has a lifespan of between two and four years, based on how frequently it is used and where it's purchased. The use-by date will be printed on the package or in the user manual.

If the key fob stopped working after being exposed to clean tapwater, remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If exposed to soapy or salty water, the chip could be fried and you will have to replace the key fob entirely.

If you're unsure whether the battery is in good condition You can test its voltage with a multimeter that is connected to both the plus and minus terminals. The voltage should be around 12 to 13 volts, but if it is lower, then the battery needs to be replaced. You can also try to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should start.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has created a fault. It is the part that transmits the signal when your key fob activates. It also acts as an alarm and prevents the vehicle from starting without the correct key.

This could be due to a number of factors including water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the electronic chip located inside is damaged. In this case you'll have to take the device apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. When the battery is clean you can try it again.

If the issue isn't resolved, it's probably a good idea to see a local Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to identify the problem and repair it for you.

Losing your Peugeot car keys could be an incredibly stressful experience. However, a professional auto locksmith can resolve the issue in just a few minutes. They can cut a new key and program it to your vehicle, so you're ready to get out on the road in the shortest amount of time. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob plays an essential part in the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message stating "anti-theft". If this happens, the only way to fix the issue is to get a new key. Auto locksmiths with experience are able to offer the service within the shortest possible time.

The chip in your Peugeot 308's key fob may become faulty for different reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, you should clean it right away. You can use a paper towel and isopropyl ethanol to clean the electronic component. The battery should be allowed to dry completely.

Sometimes keys can stop working because of radio interference. This can be caused when other devices operate on the same frequency as your Peugeot keyfob. This could be due to poor conditions or objects within the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this problem.

The Peugeot 207/308 key fob is very delicate and requires attention. It is important not to drop or throw the key fob. If you lose something, try to locate it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Be sure to disconnect the negative first, and then the positive.

Edit

Pub: 24 Apr 2024 19:17 UTC

Views: 31