25 Surprising Facts About Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be somewhat old-fashioned but it's still striking. It's not the most luxurious vehicle in its class, but it's an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can aid whether the issue is intermittent, or constant.
Water Damage
If you accidentally drop your key fob in an eddy, or it gets wet while kayaking canoeing, rafting or canyoning the fob is most likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry, dry bag when you're outside or performing activities in which the fob may be exposed to high levels of water.
It is also important to ensure that the fob is completely dry prior to opening it and re-using it. If you notice any odors coming from the fob, like an industrial smell or a sour taste like windshield washer fluid, this is another indication that it's been submerged in water.
A circuit that is wet can cause the battery's energy to drain or even explode. If you can get your keyfob 308 from the water you need to turn the button side up and shake as much water as you can prior to opening the casing. Once you have opened it, remove the battery and clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module malfunction signal interference or a damaged chip. If none of the above is the cause you can reset the system by disconnecting the 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the car prior to entering. G28 Car Keys is very useful especially during the cold winter months. Remote start systems can cease to function for a variety reasons, including the dead battery in the coin-battery.
A coin-shaped battery that is located inside the key fob will last a time of between two and four years, depending on how often it is utilized and where it was purchased. Its use-by date is typically found on the packaging or marked in the manual.
If the key fob has stopped working after exposure to clean tap water then you must remove the battery, then clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to become damaged. You'll need to replace it.
If you're not sure if the battery is defective You can test its voltage using a multimeter that is connected to both the terminals plus and minus. The voltage should read approximately 12-13 volts however, if it reads lower, the battery must be replaced. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should begin to run after this.
Faulty Receiver Module
If you don't get the "Key Detected" message, it could mean the receiver module malfunctioning. It's the part that transmits a signal to the car when your key fob is activated, that also acts as an immobiliser. It stops it from starting unless the key that you want to use is present.
The cause could be many factors, including water damage or simply aging. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water, it could be because the keyfob was in contact with it. In this scenario, you'll need to remove it and thoroughly clean it using isopropyl or electronic cleaner. When the battery is clean you can try it again.
If the problem persists, it's probably a good idea to see a local Peugeot specialist or locksmith. They can utilize a diagnostic tool in order to identify the issue and fix it.
Losing your Peugeot keys to your car can be a stressful experience. A certified auto locksmith can resolve the issue within minutes. They can cut a brand new key and then program it into your vehicle, ensuring you're ready to get off the road in the shortest time possible. Click here to find a locksmith near you.
Electronic chip malfunctions
The electronic chip in your Peugeot 308 key fob is an important part of the remote control system. If it becomes damaged, your car might not start or you may receive a message saying "anti-theft active". In this situation the only option is to replace the key. Professional auto locksmiths can provide this fastest possible time.
The chip inside your Peugeot 308's key fob could be damaged due to various reasons, including water damage, sweat or dirt. If your Peugeot key fob was exposed to dirty or soapy water, it needs to be cleaned promptly. You can employ a paper towel as well as isopropyl alcohol to wipe the electronic component. The battery must then be allowed to dry completely.
Radio interference can cause the key fob to cease working. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects around the vehicle. It is recommended that you visit a Peugeot dealer in the event of this issue.
The Peugeot Key Fob 207/308 is very delicate and requires particular care. It is crucial not to throw or drop the key fob. If you lose something, try to find it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative cable first, and then the positive.