The Simplicity Of Keku Wall Panel Fixings

Have brick panel cladding gone into a modern office block or a shop and wondered the way the wall panels have the symptoms of nothing holding them about the wall? Often there won't be any screws or connectors visible which are holding these to the wall. So how is this effect achieved?
A number of years ago accomplishing this effect could have been unthinkable and you would have found some kind of visible fixing at the pinnacle and bottom from the wall panels holding them about the wall behind, but this did look unsightly unless the screws heads were filled over.
However in filling them in you had two problems, firstly finding a colour match with the filler was very hard. Secondly in the event you filled them in then it made the panels very difficult to remove in a big hurry, that may be a problem in case you had to reach any electrical equipment or water pipes sat to their rear in a rush.
One German company recognised the need to use a wall panel fixing system that allowed panels being firmly fixed to your wall without any visible fixings showing, but also allowed these to be released quickly in the event with the need to take a panel off. This has proved being a concept that shop fitters love using because it gives such a clean look.
The Keku wall panel system works very by simply having lightweight aluminium "I" cross section beams that are like mini RSJ beams fit. These come pre-drilled with holes and so are screwed on the real wall.
A load bearing frame component will then be attached towards the beam and the relevant panel component attached to the panel, this then means the panel will then be slid into place using the panel component clipping in to place while using frame component. This forms vital, which essentially locks the panel towards the wall, but simply by sliding the panel upwards the ingredients break releasing the panel.
The fact that the beams come pre-drilled for simple assembly entails that this frame components could be attached towards the beams in a wide array of heights. This in turn allows a lot of flexibility when hanging the wall panels.
The result is wall panel fixings that may be fixed firmly, but invisibly in place but permit an incredibly high dimensional accuracy, with gaps which can be precise, yet might be varied in width.

Edit

Pub: 31 Aug 2026 01:07 UTC

Views: 1