Where Will Peugeot 308 Key Fob Be 1 Year From Right Now

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little, but it still feels attractive. It's not the most luxurious car in its class, but it is an enjoyable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid in solving the issue whether it is intermittent, or constant.

Water Damage

If you leave your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's most likely to suffer water damage. The best way to stop this from happening is to keep it in a dry, dry bag when you're going outdoors or doing things where the fob might be exposed to high levels of water.

You'll also want to ensure that the fob is dry prior to opening it and reusing it. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's submerged.

A circuit board that's wet can cause the battery to discharge its charge or even explode. If you're able to pull your 308 key fob out of the water body it was stuck in turn the button upside down and shake it out as much water as you can before opening the case. When you've opened it, remove the battery, and then clean the circuit board using a cotton swab dipped in 90-percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote entry keyless system might not work include a dead battery in the coin-cell, receiver module problems signal interference or a damaged chip. If none of the above is the issue you can reset the system by disconnecting 12 volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote start system that allows drivers to start their vehicle from the distance, allowing them to warm up or cool down the car before they enter. This feature is extremely beneficial, especially during cold winter months. The remote start system may not function due to a variety of reasons, such as an inactive coin-battery.

A coin-shaped battery that is found inside the key fob will last a time of two to four years, depending on how often it is used and where it's purchased. The date for use-by is typically printed on the packaging or in the manual.

If the key fob is no longer working after being exposed clean tapwater, remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have fried the chip. You will need to replace it.

If you are not sure the battery is faulty You can test the voltage with an instrument set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is less than 12-13 volts, you need to replace the battery. You can also try to reset the on-board computer by disconnecting the 12 volt battery for a couple of minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should now begin.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible that the receiver module has created a fault. It's the part that sends an alarm to the car when your key fob is activated, it also acts as an immobiliser. It also stops it from starting unless the key that you want to use is present.


It could be due to a number of causes, such as water damage or just getting old. If the chip inside your Peugeot 308 keyfob is damaged due to dirty tap water It could be because the keyfob was contaminated with it. In this case you will need to remove it and clean it thoroughly using isopropyl or an electronic cleaner. When the battery is clean then you can try again.

If the problem persists it is recommended to see an area Peugeot expert or locksmith. They'll be able to employ a diagnostic tool assist in identifying the problem and repair it for you.

It can be a stressful experience to lose your Peugeot car key. A certified auto locksmith will be able to solve the issue in a matter of minutes. They can program your car and cut a new functioning key for you. Find The Keylab in your area.

Electronic chip malfunctions

The electronic chip inside your Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message that says "anti-theft". In this case, the only solution is to replace the key. Auto locksmiths who are professionals can provide this service within the shortest possible time.

The chip in your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other reasons. If your Peugeot key fob has been exposed to soapy or dirty water, it needs to be cleaned right away. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to fully dry.

Sometimes keys may stop working because of radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects that are in the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you experience this issue.

The Peugeot key fob 207/308 is extremely delicate and requires special attention. It is important not to drop or throw the key fob. If you lose it, try to find it as quickly as is possible. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, then the positive.

Edit
Pub: 24 Apr 2024 16:46 UTC
Views: 11