10 Times You'll Have To Know About Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit but it's still appealing. It's not the most luxurious car in its class, but it is a pleasant and peaceful drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is intermittent or constant these tips will assist.

Water Damage

If you accidentally drop your key fob into the puddle, or it is wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to stop this from happening is to always keep it in a dry bag when you're out in the open or engaging in activities that require the fob to be exposed to a lot of water.

It's also essential to make sure that the fob is completely dried out before you open the fob and then use it. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's been submerged.

A circuit board that's damp can cause the battery's charge to drop its energy or even explode. If you can pull your keyfob 308 from the water you need to turn the button side up and shake as much water out as possible before opening the casing. Remove the battery, then wipe the circuit board clean with a cotton swab that has been submerged in 90 percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could not function include a dead coin battery, receiver module issues signal interference, an electronic chip malfunctioning. If none of these are the reason, you may try resetting the system by disconnection of the battery with 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote start system which allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the vehicle before they get in. This feature is extremely beneficial particularly during the cold winter months. But sometimes, the remote stop system stops operating due to a range of reasons, such as an unresponsive coin battery.

A coin-shaped battery in the key fob can last for a period of between two and four years, based on how often used and where it's purchased. The date of use is usually printed on the package or in the manual.

If the key fob stopped functioning after exposure to water that is clean then you must remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. In the event of exposure to salty or soapy water, the chip may be fried and you will have to replace the key fob altogether.

If you are not sure the battery is faulty you can check its voltage using a multimeter that is set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be between 12-13 volts but if it is lower, the battery needs to be replaced. If you want to, you can try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should then start after this.


Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible that your receiver module has discovered a problem. It is the part which sends out the signal when your key fob goes off. It also acts as an alarm, and stops the car from starting if you don't have the correct key.

This could be due to a number of factors including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in the electronic chip located inside is damaged. In this situation you'll need to remove it apart and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once peugeot 208 key , you can put the battery back in and try again.

If the issue is not resolved, it is a good idea that you visit a local Peugeot expert or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.

Losing your Peugeot keys to your car is a stressful experience. A professional auto locksmith can solve the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, making sure you're ready to get out on the road as fast as you can. Click here to find a locksmith near you.

A malfunctioning electronic chip

The electronic chip that is in the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message that says "anti-theft". If this occurs, the only way to fix the problem is to obtain a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest time.

The chip in the key fob of your Peugeot 308 could fail due to many reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it should be cleaned right away. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. Then, you need to let the battery completely dry.

Radio interference can cause a key fob to stop functioning. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by problems with the environment or objects close to the vehicle. If you experience this problem you should visit a Peugeot dealership.

The Peugeot key fob 207/308 is very delicate and requires attention. It is not recommended to drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.

Edit
Pub: 25 Apr 2024 06:58 UTC
Views: 17