7 Little Changes That Will Make A Huge Difference In Your Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a bit, but it still feels appealing. It's not the most luxurious car in its class, but it is an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is persistent or intermittent the following tips will help.

Water Damage

If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. The best way to stop this from happening is to always keep it in a dry container when you're outside or performing activities in which the fob may be exposed to excessive amounts of water.

It's also essential to make sure the fob has completely dried out prior to opening it and use it again. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid), this is another sign that it has been submerged.

A wet circuit may cause the battery's charge to drain or even explode. If you're able to fish the 308 key fob of whatever body of water it was stuck in turn the button upside down and shake it out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board clean with a cotton swab that has been dipped in 90-percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system could fail to function include an empty coin battery, receiver module issues, signal interference, or an electronic chip that is defective. If none of the above is the reason you can reset the system by disconnecting a 12 volt battery from your car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote start system that allows the driver to start the car from afar while warming up or cooling down the vehicle prior to getting in. This feature is very useful, especially in the cold winter months. However, sometimes the remote start system stops operating due to a range of reasons, including a dead coin battery.

The coin-shaped battery contained inside the key fob can last between two and four years depending on the frequency with which it is used, where it was purchased, and how it is used. The date of use is typically printed on the package or marked in the manual.

If the key fob stops working after exposure to clean tap water then you must take the battery off, clean the electronic chip using a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have fried the chip. It is recommended to replace it.

If you're unsure if the battery is defective, you can test the voltage with an instrument set to the car's voltage range and connected to the plus and minus terminals. The voltage should be between 12-13 volts, but if it is lower, the battery must be replaced. You can also try to reset the on-board computer by disconnecting the battery with 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible that the receiver module has discovered a problem. It's the part that transmits an indication to the car when the key fob is activated, which also acts as an immobiliser and prevents it from starting unless the correct key is in place.

This could be due to a number of reasons, including water damage or simply the aging process. If the electronic chip within your Peugeot 308 keyfob is damaged due to dirty tap water it could be because the keyfob was in contact with it. In this instance, you'll have to take it off and clean it thoroughly using isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the problem persists it is recommended to consult the local Peugeot expert or locksmith. They will be able to employ a diagnostic tool identify the problem and repair it for you.

It is stressful to lose your Peugeot car key. A professional auto locksmith will be able to solve the issue in a matter of minutes. They can cut a brand new key and then program it into your vehicle, ensuring you're back on the road again in the shortest time possible. Click here to find a local locksmith near you.

Faulty electronic chip

The chip inside your Peugeot 308 key fob is a very crucial component of the remote control system. If the chip is damaged, you may have problems starting your car or receive a message that says "anti-theft". In this situation, the only solution is to replace the key. Fortunately, professional auto locksmiths can offer the service within the shortest period of time.

The chip in your Peugeot 308 key fob can be damaged due to water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned right away. peugeot replacement key cost uk can wipe the electronic component with a paper towel soaked in isopropyl Alcohol. Then, you need to allow the battery to dry completely.

Radio interference can cause a key fob to stop working. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects around the vehicle. It is recommended that you visit a Peugeot dealer in the event of this issue.

The Peugeot Key Fob 207/308 is delicate and requires particular care. It is imperative not to throw or drop the key fob. If you lose something, try to find it as soon as possible. You can reset the onboard computer by disconnection of the battery for a few minutes. Disconnect the negative cable prior to the positive.

Edit Report
Pub: 24 Apr 2024 20:39 UTC
Views: 28