10 Wrong Answers To Common Peugeot 308 Key Fob Questions: Do You Know The Right Ones

G28 might be catching on a bit however it's still appealing. It might not be the most luxurious car in its class - an Ford Focus or Volkswagen Golf will protect you from surface imperfections - but it's still a pleasant and comfortable drive.

We often get asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will help whether the problem is persistent or intermittent.

Water Damage

If you happen to leave your fob in the midst of a puddle or splash it with water while kayaking, swimming canoeing, rafting, or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry container whenever you are outside or perform activities that expose it to excessive amounts water.

It's also essential to make sure the fob has completely dried out prior to opening it and use it again. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) This is a further indication that it's been submerged.

A circuit board that's wet can cause the battery to discharge its charge, or even explode. If you can pull your keyfob 308 out of the water you need to turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab that has been dipped into 90-percent alcohol.

Other reasons why your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module issues signal interference, or a damaged chip. If none of these causes the reason, you may try resetting your system by disconnecting the battery at 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely beneficial particularly during the cold winter months. Remote start systems may cease to function for a variety reasons, such as a dead coin-battery.

A coin-shaped battery that is found inside the key fob can last for a period of between two and four years, depending on how often it's used and the location where it was purchased. Its use-by date is typically printed on the package or written in the manual.

If the key fob has stopped working after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have fried the chip. It is recommended to replace it.

If you're not sure whether the battery is defective, you can check its voltage using an instrument connected to the plus and minus terminals. The voltage should range from 12-13 volts but if it's lower, the battery needs to be replaced. Alternatively, you can try to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should be able to start after this.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, then it's possible that the receiver module has developed a fault. It's that part that sends an alert to the car when your key fob is activated, that also acts as an immobiliser. It also stops it from starting unless the correct key is used.

The cause could be various factors, including water damage or just aging. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the chip that is located inside may be damaged. In this instance, you'll have to take it off and clean it thoroughly using isopropyl or electronic cleaner. Once the battery is dry you can try it again.

If the issue is not resolved, it is recommended to visit the local Peugeot expert or locksmith. They can use a diagnostic tool in order to identify the issue and then fix it.

It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can solve the issue in a matter of minutes. They can cut a new key and programme it to your vehicle, ensuring you're back on the road again in the shortest time possible. Click here to find a locksmith near you.

Faulty Electronic Chip

The chip inside the Peugeot 308 key fob is an important component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this situation the only option is to replace the key. Auto locksmiths with experience are able to provide this fastest possible time.

The chip in your Peugeot 308's key fob may become faulty for a variety of reasons, such as water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it immediately. You can wipe the electronic component with paper towels soaked with isopropyl Alcohol. Then, you need to let the battery completely dry.

Radio interference can cause the key fob to stop functioning. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects around the vehicle. If you have this issue you should visit an Peugeot dealership.

The Peugeot Key Fob 207/308 is delicate and needs special care. It should not be dropped or throw it around. If you lose it, try to find it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Disconnect the negative cable before the positive.

Edit Report
Pub: 29 Jun 2024 02:41 UTC
Views: 7